Qu-Bot Hardware
Hardware Add-ons TroubleshootQ1. Can I add some new circuits to my Qu-bot? If so, which peripherals can I attach?
(A1) Yes. New circuits or peripherals can be added to your Qu-bot. For that you must be an advanced user or experienced enough to work with AtMega16/32 boards.
You can add any peripheral e.g. LEDs, switches, 4x4 Keypad, LCD, SSD (7 segment display), Sensors, motors – DC geared, stepper, servos etc... For that matter you must know the pin-outs of the board.
It can be downloaded from our Qu-bot "downloads" section.
NOTE: -
All I/O ports of ATMega16 are connected to peripheral devices. Hence extra peripherals cannot be added without losing capacity of other peripherals onboard.
Also the new peripherals will not be visually programmable. However you can use these peripherals if you use any other compiler.
Also the board will be void any warranty once any changes to the board hardware are done.
--> Check out the following subjects, if your Qu-Bot has any of the following problems...
01. Battery & Charging of Qu-bot.
Download PDF |
View page
02. C Programming of Qu-bot.
Download PDF |
View page
03. Hardware add-ons of Qu-bot.
Download PDF |
View page
04. IR Remote of Qu-bot.
Download PDF |
View page
05. LCD of Qu-bot.
Download PDF |
View page
06. Line Follower using Qu-bot.
Download PDF |
View page
07. Micro-mouse using Qu-bot.
Download PDF |
View page
08. Motors of Qu-bot.
Download PDF |
View page
09. PC Controlled Qu-bot.
Download PDF |
View page
10. Sensors of Qu-bot.
Download PDF |
View page
We encourage & support quality robotics training kits; Qu-bot is one such :-)
